New to Full Metal Jacket, Sojourn Group is a local company innovating in MLOK accessories for laser and light pressure pads. We're excited to be one of their fist distributors as they're pumping out some cool new stuff.
The 11-1 M (Dual Rib) was designed to allow for the ergonomic placement of Modlite ModButton Lite pressure switches (either single or dual lead versions) at the 11-O’Clock or 1-O’Clock positions on a handguard without disrupting the placement of items such as laser/illuminators at the 12-O’Clock position on a handguard. Additionally, thanks to the design of the 11-1, should a pressure switch need to be replaced, it is not necessary to remove accessories mounted at the 12-O’Clock position on the rail in order to do so.
Features:
- A very low-profile that allows for simultaneous mounting of equipment on the 12-O’Clock Picatinny rail.
- Made in the USA out of injection molded, glass-filled polymer.
- Provides a secure and easy way to place Modbutton Lite switches at the 11:30 or 1:30 positions on MLOK handguards.
- Tactile feedback to the user to prevent unintentional switch activations.
Instructions
- Ensure that your weapon is unloaded with the bolt either locked to the rear or removed from the receiver. Do not neglect this step, as it pertains to life safety.
- Ensure that the M-LOK nuts are backed out enough from the 11-1 that the M-LOK nuts can seat properly onto the M-LOK rail. At this point, if you desire to use thread locker, add a drop or two to each screw. We recommend blue thread locker.
- Position the 11-1 into the desired location on the M-LOK rail, inserting the pressure pad underneath the 11-1 so that the cable is routed properly around the mounting hardware. Ensure that the 11-1 and pressure pad are fully and properly seated against your hand guard prior to tightening the fasteners.
- Tighten the M-Lock hardware to 15 inch/pounds (1.7 newton meters).
- Verify that the pad is held securely in place by the 11-1, and connect your pressure pad to the appropriate device.
- Employ your device hassle-free from tape or zip-tie solutions that you’ve used prior.
- Prior to installation, properly clear your weapon and confirm that it is safe. Safety is everyone’s priority.
- Torque driver with 1/8” Hex Bit (in a pinch, a #3 or a #3.5 will work too).
- Thread locker (medium/blue) if desired. DO NOT use red thread locker.
- DO NOT exceed 15 inch pounds (1.7 newton meters) of torque.
All hardware necessary for attachment directly to M-LOK Slots is included and and no modifications to the M-LOK hand guard or forend is required.